PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627

Overview

PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627 is a serial communication module for the Phoenix Contact Inline distributed I/O system, supporting RS485 and RS422 interfaces. It serves as a point-to-point serial gateway between the Inline local bus and external serial field devices, widely supplied as exchange spare for machine automation, weighing systems, instrumentation and legacy serial communication cabinet overhaul.

Features

PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627 supports freely configurable serial parameters including baud rate, data bits, parity and stop bits. It can run ASCII, 3964R and user-defined framing protocols; Modbus RTU master or slave operation is supported by configuration within the control program. The module isolates the serial side from the Inline bus side to suppress ground loop noise and voltage transients common on long field cable runs.

PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627 provides transmission and reception buffer management independently of the PLC scan cycle, reducing communication load on the controller. Front panel LED indicators show bus status, transmit activity, receive activity and diagnostic faults for fast field troubleshooting. It supports hot-swap replacement inside the Inline station without shutting down the entire I/O rack under proper system configuration. It is configured with Phoenix engineering software and transmits timeout, framing error and checksum fault diagnostics to the PLC and SCADA logging system. It meets CE standards and has an IP20 rating for cabinet installation.

Specs

PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627Platform: Phoenix Contact Inline I/O system Type: RS485 / RS422 serial communication module Part number: 2863627 Bus interface: Inline local bus Serial interface: RS485 / RS422, terminal block connection Isolation: galvanic isolation between serial side and Inline bus Supported protocols: ASCII, 3964R, user-defined, Modbus RTU (program-configured) Mounting: snap onto Inline station terminal base Protection class: IP20 This is not an analog or discrete I/O module; it is a dedicated serial communication processor for Inline stations. PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627 is widely supplied as service replacement spare for serial instrument communication failures.

Principle

PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627 exchanges data with the Inline bus coupler and PLC via the Inline local bus. It converts digital process data from the PLC into serial frames and transmits them over RS485/422 to slave instruments. Incoming serial data is validated for parity and framing errors before being stored in receive buffers for the PLC to read. If cable break, timeout or communication error occurs, the module sets diagnostic bits to trigger alarms in the control program. The galvanic isolation of PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627 prevents potential ground potential differences from damaging the I/O station and controller.

Applications

PHOENIX CONTACT IL RS 485/422-PRO-PAC 2863627 is deployed to connect weigh indicators, flow transmitters, energy meters, legacy drives and barcode scanners on packaging machinery, metalworking equipment, water treatment skids and material handling lines. It is selected for spare inventory and station retrofit projects for existing Phoenix Inline serial communication systems.

SEO Description: