1. General Information

1.1 Product Overview

1.2 Model Code Meaning

• TPM11B: Series designation (MOVITRANS power converter, B‑version)

• 009: Power rating (900 / 1000 W)

• ENB: Hardware configuration, circuit revision

• 3A2: Terminal assignment & electrical specification variant

• 1: Standard version (no options)

1.3 Safety Instructions

• Only qualified electricians may install, wire, or service this unit.

• Disconnect all power before opening the enclosure or performing maintenance.

• Do not exceed rated voltage/current; risk of damage and fire hazard.

• Protect from moisture, dust, and corrosive environments.

• Ensure reliable protective grounding during operation.

• Do not modify or disassemble internal components.

2. Technical Specifications

2.1 Electrical Data

• Input: 135 VAC, 7.5 A, 25 kHz (high‑frequency AC)

• Output: 0–200 VDC, 5 A, max. 1000 W (1 kW)

• Protection: Overcurrent, overvoltage, overtemperature, short‑circuit

• Auxiliary Supply: 24 VDC / 2 A (for control circuits)

2.2 Mechanical & Environmental

• Dimensions: 205 × 160 × 63 mm

• Weight: Approx. 1.95 kg

• Protection Class: IP20 (indoor use)

• Operating Temperature: 0 °C to +40 °C

• Storage Temperature: −25 °C to +70 °C

• Humidity: ≤ 85% RH, non‑condensing

3. Installation

3.1 Mounting

• Install vertically on a rigid, flat surface.

• Maintain 100 mm clearance around the unit for cooling.

• Avoid heat sources, direct sunlight, and strong vibration.

• Secure with appropriate screws (torque per manufacturer standard).

3.2 Wiring

1. Connect 135 VAC high‑frequency input to primary terminals.

2. Connect 0–200 VDC output to load (e.g., motor/actuator).

3. Connect protective earth (PE) to dedicated grounding terminal.

4. Connect 24 VDC control supply if required.

5. Use cables with sufficient cross‑section; tighten terminals to specified torque.

6. Verify all wiring for shorts or reverse polarity before power‑on.

4. Operation

4.1 Commissioning

1. Confirm correct wiring and grounding.

2. Power on gradually; measure input (135 VAC) and output (0–200 VDC).

3. Run no‑load for 5–10 minutes; check for abnormal noise or overheating.

4. Apply load incrementally; verify output stability.

4.2 Operating Limits

• Continuous operation: ≤ 80% load at 40 °C.

• Do not run at full load continuously in high ambient temperatures.

• If overtemperature or fault occurs, shut down immediately.

5. Maintenance

• Every 6 months:

  • Check terminals for looseness, cables for damage/aging.

  • Inspect PE connection integrity.

  • Clean dust from enclosure and ventilation slots (dry brush only).

• No lubrication required.

• Use genuine SEW‑EURODRIVE parts for replacement.

• For internal faults, contact official service.

6. Troubleshooting

• No DC output: Check 135 VAC input, fuses, wiring, and enable signal.

• Overheating: Excessive load, blocked ventilation, or ambient temperature too high.

• Unstable output: Loose terminals, poor grounding, or load mismatch.

• Abnormal noise: Internal component fault; power off and inspect.

7. TOP‑ANGEBOT / TOP OFFER

8. Disclaimer