This unit is a power converter module manufactured by SEW-EURODRIVE, designed for the MOVITRANS contactless energy transfer system. It converts high-frequency AC input into regulated DC power, widely used in industrial automation, conveyor systems and servo drive applications.

TPM11A refers to the product series. 009 stands for the power rating. ENB represents the hardware configuration and circuit version. 2A2 defines the terminal layout and electrical specifications. The final digit 1 indicates the standard basic version without extra optional functions.

Only qualified electricians are allowed to perform installation, wiring and maintenance work. Cut off all power supplies before opening the enclosure or carrying out servicing. Do not exceed the rated voltage and current to avoid component damage and safety hazards. Keep the unit away from moisture, dust and corrosive substances. Ensure reliable protective grounding during operation. Do not disassemble or modify the internal structure arbitrarily.

Input voltage is 135 V AC with a rated input current of 7.5 A and operating frequency of 25 kHz. The output ranges from 0 to 200 V DC, with a rated output current of 5 A and maximum output power of 1000 W. The unit adopts built-in over-current, over-voltage and over-temperature protection functions.

The overall dimension is 205 mm × 160 mm × 63 mm. The total weight is approximately 1.94 kg. The protection class is IP20 for indoor installation. The applicable operating temperature ranges from 0 °C to 40 °C, and the storage temperature ranges from -25 °C to 70 °C. The unit is suitable for use under non-condensing humidity conditions.

Mount the module vertically on a firm flat panel or wall. Reserve sufficient space around the unit for heat dissipation. Keep clear of heat sources and strong vibration equipment. Fasten all mounting screws firmly to ensure stable installation.

Connect the high-frequency AC input cables to the corresponding input terminals. Connect the DC output cables to the load equipment. Run the protective earth wire to the dedicated grounding terminal. Use cables with suitable cross-sectional area and tighten all terminal screws to the specified torque. Check all wiring carefully to rule out short circuits before power-on.

After confirming correct wiring, switch on the power supply step by step. Check the input and output voltage values with a measuring instrument to make sure they meet standard requirements. Run the unit under no load for several minutes, and observe for abnormal noise or excessive temperature rise.

Operate within the full rated range at all times. Do not run the unit continuously under full load in high ambient temperature. Cut off power immediately once abnormal phenomena such as overheating, abnormal sound or smoke appear.

Inspect the unit regularly every six months. Check whether terminals are loose, cables are aged or damaged, and the grounding connection is reliable. Remove accumulated dust on the surface and ventilation slots with a dry soft brush. This module requires no regular lubrication. Please use original genuine parts for replacement and repair. Contact the official service team for professional support if internal faults occur.

If there is no DC output, check the input power, fuses and wiring connections first. If the unit overheats, verify whether the load exceeds the rated value or the ventilation is blocked. Unstable output voltage is usually caused by poor contact of terminals or mismatched load parameters. Turn off the power and inspect the internal circuit if abnormal noise occurs during operation.

This product is marked as Top Offer. It is original new stock with complete performance. Standard warranty service is provided and goods can be delivered promptly. The quantity is limited and available while stock lasts.

All technical specifications are subject to change without prior notice. The manufacturer shall not be responsible for equipment damage or personal injury caused by improper installation, wrong operation or use beyond rated parameters.