I. Model Explanation in Detail

330180: 3300 XL 8mm Front-End Base Model (50Ω)

X1:

X: Standard Temperature Version (not ETR High Temperature)

1: DIN Rail Installation (with DIN Card)

05: System Total Length 5m (Probe Cable + Extension Cable Combined)

Compare with your previous X2-05:

X1 = Standard Temperature (-35℃ ～ +100℃)

X2 = ETR High Temperature (-55℃ ～ +232℃)

Installation Method is all DIN, Length is all 5m.

II. Core Parameters (Standard Temperature Version)

Compatible Probe: 330191 Standard Temperature 8mm Probe (50Ω)

Compatible Extension Cable: 330190 Series 5m (50Ω)

System Impedance: 50Ω (Must be Fully Matched)

Power Supply: -17.5～-26VDC (Typical -24VDC, ≤12mA)

Sensitivity: 7.87mV/μm (200mV/mil)

Linear Range: 0.25～2.3mm

Frequency Response: 0～10kHz

Operating Temperature (Front-End): -35℃ ～ +100℃

Output: Negative Voltage Proportional to Gap (Static + Dynamic)

Installation: DIN Rail (35mm)

Size: Approximately 81×35×58mm; Weight Approximately 0.25kg

III. Typical Combinations (5m Standard Temperature System)

Probe: 330191-00-26-10-00 (Equipped with 1m Cable, Standard Temperature)

Extension Cable: 330190-040-00-00 (4m, Combined 5m)

Front-End: 330180-X1-05 (5m, DIN, Standard Temperature)

Monitoring Modules: 3500/40 (Axial Vibration), 3500/42 (Axial Displacement)

IV. Application Scenarios (Key Differences from X2)

X1 (This Model):

General Industrial Environment, Probe Temperature ≤100℃

Steam Turbine / Compressor Non-High Temperature Area, Fan, Motor, Pump

Normal Temperature in Cabinet Area (<60℃)

X2 (ETR High Temperature):

Probe Position 100℃～232℃ (e.g. Near Steam Turbine Cylinder)

Must be equipped with 330191-ETR High Temperature Probe

V. Installation Tips

Must be 50Ω Fully Matched: Probe / Extension Cable / Front-End Cannot Be Mixed with 75Ω

Reference Gap: 1.27mm (50mil)

Cable Cannot Be Cut, Avoid Small Radius Curves

Shield Layer Connects to Control Cabinet at One End

Front-End Operating Temperature **≤60℃**, Away from Heat Source