Model Definition

DKC: ECODRIVE series servo drive controller

01.3: Hardware platform version

004: 4 A continuous rated output current

3: Low voltage class

MGP: Pre-installed dedicated standard application firmware

Technical Specifications

Electrical Parameters

Three-phase input voltage: 200–240 V AC, 50/60 Hz

Continuous output current: 4 A

Peak output current: 8 A

Nominal DC bus voltage: 300 V DC

Control power supply: 24 V DC ±20%

Compatible motors: Small-size MKD, MKE series synchronous servo motors

Mechanical & Environmental Parameters

Cooling mode: Internal forced air cooling

Dimensions (W×H×D): 55 mm × 350 mm × 250 mm

Weight: Approximately 4.5 kg

Operating temperature: 0 °C to +45 °C

Storage temperature: -30 °C to +85 °C

Protection class: IP20

Interface and Communication Configuration

Motor feedback: Supports incremental encoder signals

Digital I/O: Integrated 24 V DC input and output terminals for enable, limit and fault signals

Control interface: Analog command and pulse command control

Communication: Optional fieldbus expansion modules

Diagnostics: LED indicators and digital display for operating status and fault codes

Core Functions

Supports torque, speed and position control modes

Light load design for stable operation under low power conditions

Factory preloaded MGP firmware for general motion tasks

Full protection against overvoltage, undervoltage, overcurrent, overheating and short circuit

Built-in homing, jog and basic positioning functions

Small footprint to save cabinet space

Application Scenarios

Light-load auxiliary axes of CNC equipment

Small packaging machinery, labeling equipment

Precision conveying and sorting devices

Laboratory automation and small assembly stations

Replacement and retrofit of old low-power DKC series drives

Usage and Maintenance

Mount the drive vertically and reserve sufficient ventilation space

Complete all power, motor and signal wiring before powering on

Adopt shielded cables for encoder and signal lines to reduce interference

Clean cooling fans and dust filters every 3 to 6 months

Regularly check terminal tightness and indicator status

Perform parameter setting and commissioning via dedicated configuration software