Model Explanation

DDC1.1: DDC series, hardware V1.1, first-generation IP65 air-cooled platform

K050A: K = natural cooling; continuous / peak 50A; A = standard noise

DL01: D = digital encoder feedback; L = DLC single-axis positioning module; 01 = standard positioning version

00: Function code 00 = basic version; no factory firmware (FW must be purchased separately)

Basic parameters (K050A platform)

Input: Three-phase AC 380–480V ± 10%, 50/60Hz, 7.5kVA

Continuous output: 50A; peak 50A

Power: continuous 2.2kW; peak 4kW

PWM carrier: 4kHz

Braking: built-in regenerative braking, peak 10kW, continuous 0.25kW

Protection: IP65 (dust-proof, oil mist-proof)

Temperature: +5°C to +45°C (rated), maximum + 55°C (derated)

Weight / size: approximately 12kg; 450×130×280mm

Altitude: ≤ 1000m  (No reduction factor)

Interface and Communication

Motor Feedback: Digital encoder (compatible with MDD/MKD series)

Control Core: Built-in DLC single-axis positioning module (programmable positioning independently)

Debugging Port: RS232 (DDS2PC software)

I/O: 8DI/8DO (24VDC, for positioning trigger / limit)

Expansion Slot: U1–U3 (optional fieldbus card)

Core Functions (DL01-00 Basic Positioning Edition)

Independent Single-axis Positioning: Built-in DLC module, point position control can be completed without an upper computer

Three Closed-loop: Position / Speed / Torque Control

Positioning Function: Point-to-point, reset, soft limit, position following

Basic Diagnosis: Overcurrent / Overvoltage / Overheat / Short-circuit protection

Power-off parameter retention, built-in regenerative braking

No firmware operation is possible, DIAX02 firmware programming is required separately

Differences from the same series

DL01-00: Single-axis positioning basic edition, no firmware

DL01-00-FW: Single-axis positioning basic edition, pre-installed firmware, ready to use upon power-on

DA01-00: Analog control edition (without positioning module)

DS50/DS68: SERCOS optical fiber bus edition (multi-axis synchronization) Application scenario

Single-axis positioning of machine tools (such as tool magazine, worktable movement)

Single-axis independent positioning stations for packaging, textile, and electronic manufacturing

Replace old DDC drivers and adapt to MDD050A/MKD050A motors