DDC01.2-N100A-DS68-00-FW_Ningde Androld Automation Equipment Co.,Ltd.

May 26, 2026

DDC01.2-N100A-DS68-00-FW

Full Model Analysis DDC01.2: DDC series, hardware version 1.2 (IP65, air-cooled) N100A: Three-phase 220/230V, 35A continuous / 100A peak, 6kW continuous / 17kW peak DS68: U1-U4 full-slot combination (fixed configuration: SERCOS+PLC + feedback + cover plate) 00: Combined hardware version 00 (basic version) FW: Pre-installed standard firmware DSM02.1-FW, no additional purchase required, ready to use upon power-on DS68 4-card fixed configuration (core) U1: DSS01.3-FW - SERCOS-I optical bus (μ-level synchronization, 32-axis linkage) U2: CLC-D02.3 - Built-in PLC / motion control (independent programming, electronic cam) U3: DEA28.1 - Digital encoder feedback (compatible with MDD/MKD motors) U4: COVER - Cover plate (no module, reserved for expansion) U5: DSM02.1-FW - System firmware (pre-installed)

Description

Electrical and mechanical parameters (N100A)

Input: 3×220–230V ±10%, 50/60Hz

Output: 35A continuous / 100A peak; 6kW continuous / 17kW peak

Protection: IP65 (dustproof, low-pressure water spray protection)

Cooling: Forced air cooling, with heat dissipation of approximately 500W

Brake: Built-in brake unit, 0.25kW continuous / 20kW peak

PWM frequency: 4kHz

Weight / Dimensions: Approximately 22kg; 517×165×298mm

Key differences from DS68-00 (without FW)

DS68-00: Bare machine, without firmware, must purchase DSM02.1-FW separately to operate

DS68-00-FW: Factory pre-programmed with firmware, direct communication, parameterization, trial run Application scenario

High-end CNC machines (machining centers, lathes, grinders) equipped with MTX system

Multi-axis synchronization + local control hybrid production line (electronic cams, linkage + independent workstations)

Small and medium-sized CNC equipment without additional PLC (comes with motion control)

Contact Info