1. Model Analysis (DDC01.1-K200A-DL02-xx)

DDC: Digital Drive Controller (Digital Drive Controller)

01.1: The 1st generation, hardware version 1

K200A: K = Air-cooled; 200 = 200A; A = Standard Noise

DL02: D = Digital Feedback; L = DLC + Analog Quantity; 02 = Enhanced Function Set

-00: Pure Hardware (No Firmware); -01: Hardware Revision; -FW: Factory Pre-installed DLC Firmware

2. Key Technical Parameters (Common to the Series)

Electrical

Input: 3×AC 380–460V, 50/60Hz

Control Power Supply: 24VDC

Continuous Output: 200A; Peak: 400A (1s)

DC Bus: ≈700VDC

Switching Frequency: 4kHz

Mechanical and Environmental

Size (H×W×D): ≈360×225×261mm

Weight: ≈18kg

Protection: IP65

Operating Temperature: 0°C～+45°C (Full Load)

Control and Interface

Mode: Position (DLC) / Speed / Torque (DLC + Analog)

Feedback: Digital Servo (MDD/MKD, Multi-Wire Encoder)

Command: DLC Bus + ±10V Analog Quantity (Hybrid Control)

Communication: RS-232/485 (Diagnosis), DLC Bus

Safety: STO, Overcurrent, Overvoltage, Overheat Protection

3. Core Differences between DL02 and DL01

DL01: Basic DLC, Standard Positioning + Analog Quantity, Limited Diagnostic Function

DL02: Enhanced DLC

Extended Positioning Function (Electronic Gear, Synchronization, Zero Return Enhancement)

More Comprehensive Diagnostic and Status Monitoring

Optimized DLC Bus Communication Stability

Compatible with More MDD/MKD Motor Models

4. Common Complete Models

DDC01.1-K200A-DL02-00: Pure Hardware, No Firmware

DDC01.1-K200A-DL02-01: Hardware Revision, No Firmware

DDC01.1-K200A-DL02-01-FW: Hardware + Pre-installed Enhanced DLC Firmware (Common)

5. Application Scenarios

High-power single-axis positioning (200A), requires DLC + Analog Quantity Hybrid Control

High-end CNC, Heavy-duty Gantry, Large Milling/Cutting Machines

Equipment requiring Electronic Gear, Synchronization Control, Advanced Diagnosis

6. Compatible Motors

MDD Series: MDD093A, MDD112A, MDD132A (200A Frame)

MKD Series: MKD090B, MKD112B, MKD132B