3A59324G01
Description
Part No.: 3A59324G01
Manufacturer: Original Westinghouse (later acquired by Emerson Automation, USA)
Type: Q-Line rack plug-in switching power supply for OPR/MMI operator station chassis, compatible with WDPF & early Ovation legacy DCS system; non-interchangeable with 3A59323 series (3A59323G01/G02 for standard I/O rack, this for workstation cabinet power supply).
Original new production discontinued; available stock: certified refurbished & surplus tested used spare parts for power plant DCS maintenance.
Net Weight: 1.42kg, standard Eurocard board dimension for Q-Line slot installation.
2. Electrical Specifications
Input: Dual AC+WESTBUS backplane DC dual-input power design
Output: +5VDC、+12VDC、-12VDC multi-channel stabilized output, total rated power 30W (higher than 3A59323’s 25W)
Protection: Independent OVP(overvoltage), OCP(overcurrent), short-circuit, overheat shutdown for each output rail
Indicator: Front panel LED for power input, each channel output status & overheat fault alarm
Ambient: Operating temp: 0℃~+55℃; Storage: -40℃~+85℃; UL safety & CE EMC certified for industrial control cabinet
3. Core Functions
Dedicated power feeding for MMI/OPR operator station mainboard, communication board and peripheral interface circuits inside workstation rack
Fault isolation: single-channel failure cuts off only faulty loop without impacting whole workstation power supply
Fault status uploaded via WESTBUS bus to DPU controller for system fault logging & HMI alarm prompting
Supports single-slot hot swap; replace faulty module without full workstation cabinet power cut-off
4. Difference vs 3A59323G01/G02
Rated output power upgraded to 30W (3A59323 series is 25W), designed for higher power consumption of operator station mainboard
Internal circuit optimized for MMI display & communication load anti-interference, stronger suppression of display harmonic interference
PCB layout customized for OPR workstation backplane pin definition, cannot plug into ordinary I/O rack slot of 3A59323 series
5. Application Scope
6. Installation & Maintenance
Strict ESD anti-static operation required; cut corresponding slot power before plug/unplug module
Spare modules stored in constant-temperature anti-static warehouse; quarterly powered burn-in test recommended to prevent capacitor aging and early failure
Get a Quote