Model Explanation

DKC: ECODRIVE Full Digital Servo Drive Series

10.3: CS Compact Small Power Hardware Model

008: Rated Continuous Output Current 8Arms

3: Low Voltage DC 300V Bus, Single Phase / Three Phase AC 200~240V Input

MGP: Pre-installed MGP Control Board, Built-in Factory Firmware, Ready for Debugging and Operation upon Power On Technical Specifications

Main power supply: Single-phase / Three-phase AC 200~240V ± 10%, 50/60Hz; External DC 24V control power supply

DC bus: Nominal 300VDC, Overvoltage protection 360VDC, Built-in pre-charging and integrated braking circuit

Output performance: 8A continuous rated, 230% overload 350ms, Carrier 8kHz, Maximum output frequency 1200Hz

Heat dissipation: Natural air cooling, Size W35×H210×D210mm, Net weight 2.2kg, IP20 cabinet installation

Environment: Full-load operation at 0~45℃, Altitude ≤ 1000m; Storage - 25~+80℃, No condensation or damp environment is allowed

Interface and communication configuration

Power terminals: L/N single-phase or L1/L2/L3 three-phase incoming lines, U/V/W motor terminals, Brake external terminals

Encoder interface: TTL incremental ABZ, Rotary transformer compatible, With encoder power output

Control terminals: DI/DO (Enable, Limit, Origin, Brake), ±10V analog instructions, Pulse direction input

Communication: RS232 debugging port (DriveTop parameter reading and writing); PROFIBUS/CANopen/DeviceNet require selected communication sub-card Core function

The MGP board integrates a three-ring closed-loop control system and supports three modes: ±10V analog speed regulation, pulse position control, and I/O-triggered internal multi-segment positioning program; it comes with origin reset, soft and hard limit functions, and sequential linkage with motor braking; it has full fault locking protection for overcurrent, overvoltage, undervoltage, overheating, and encoder breakage; it also displays fault codes on the digital tube. Applicable scenarios

Small dividers, electronic assembly equipment, label feed shafts, micro winding machines, precision belt conveying equipment.

Usage and Maintenance

1.3 The low-voltage model is prohibited from being connected to AC380V high voltage; only AC220V power supply is allowed;

2. The entire machine comes with firmware, and replacing the motor only requires DriveTop to automatically identify the motor parameters;

3. For light loads, built-in braking is used; for high-frequency reciprocating loads, it is recommended to connect an external small braking resistor;

4. The FW bare base of the same specification can be interchanged with this machine only after installing the MGP board.