Product Description

Model Number Interpretation

• 45C: Prefix for Reliance AutoMate 45C-series control components.

• 364: Designates 8-channel ±10VDC analog output module.

• 45C-364 = 45C364: Hyphen is standard industrial part number formatting; both are identical.

• No standard lettered suffix; revisions tracked via serial numbers.

Technical Specifications

• Type: Analog Output Module (Bipolar Voltage)

• Channels: 8 independent, isolated outputs

• Output Signal: ±10VDC (bipolar)

• Resolution: 12-bit

• Isolation: Electrical isolation between analog field side and PLC logic side

• Terminals: 20-pin removable screw terminal block

• Backplane Power: 5VDC from rack backplane

• Analog Power: Internal or external selectable

• Slot Occupation: 1 standard 45C-series slot

• Weight: ~0.95 kg (2.10 lbs)

• Operating Temperature: 0°C to +55°C

• Compatibility: AutoMate 20/20E, AutoMax PLC, 45C-series I/O racks

Interface & Configuration

• Installation: Single-slot mounting in 45C rack; power off before insertion/removal.

• Output Configuration: Fixed ±10VDC (no current option); DIP switches for address/channel enable.

• Calibration: Zero and span potentiometers per channel for on-site trimming.

• Status LEDs: Power, Run, and Fault indicators on front panel.

Core Functions

• D/A Conversion: Converts PLC digital values to ±10VDC bipolar analog signals for precise control.

• 8-Channel Independent Control: Simultaneously drives 8 bipolar devices without crosstalk.

• Noise Isolation: Protects PLC from field-side electrical noise and surges.

• High Precision: 12-bit resolution with trim pots for accuracy optimization.

Application Scenarios

• Process Control: Bipolar valve positioning, actuator control, and servo drive interfaces.

• Test & Measurement: Precision analog output for calibration and signal simulation.

• Legacy System Maintenance: Direct replacement for 45C-364 in existing AutoMate/AutoMax installations.

Usage & Maintenance

• Installation: Power off rack before inserting module; secure screws for good backplane contact.

• Wiring: Use shielded twisted-pair cables for analog signals; single-end ground shield to reduce noise.

• Configuration: Set DIP switches and calibrate zero/span before powering on.

• Maintenance: Inspect LEDs and terminal tightness periodically; keep module clean.