0-51811-1
Description
1. General Information
Manufacturer: Reliance Electric (Rockwell Automation)
Part Number: 0-51811-1 (0518111)
Product Type: Voltage Test Module / Diagnostic Card
Application: MaxPak Plus, VS Spindle Drives, legacy Reliance drive systems
Function: In‑system voltage measurement, signal diagnostics, calibration, and troubleshooting of drive power & control circuits
Status: Obsolete; available as used / refurbished / new old stock
Warranty: 12 months (refurbished / tested units)
2. Electrical Specifications
Power: +5 VDC, ±15 VDC (from drive backplane)
Measurement Ranges: AC/DC voltage, 0–600 VDC, 0–480 VAC
Input Impedance: High impedance (>1 MΩ) to avoid loading circuits
Accuracy: ±0.5% full scale
Isolation: 1000 VDC (test points to logic)
Protection: Overvoltage, transient, ESD protection
Test Points: Front‑panel accessible voltage / signal test jacks
3. Physical & Mechanical
Form Factor: Standard Reliance rack‑mount module
Dimensions (W×H×D): ~220 × 150 mm
Weight: ~0.7–0.9 kg
Front Panel: Test jacks, LED indicators, calibration potentiometers
Connectors: Edge connector (backplane), front‑panel test ports
Construction: Industrial FR4 PCB, conformal coated
4. Environmental Ratings
Operating Temp: 0°C to +60°C
Storage Temp: -20°C to +70°C
Humidity: 5%–95% RH, non‑condensing
Vibration: 10–150 Hz, 0.1 mm amplitude (cabinet rated)
5. Compatibility
Drive Systems: MaxPak Plus, VS Spindle Drives, FlexPak 3000, GV3000
Related Modules: 0-51805-5 (pulse input), 0-51772-3R (control board)
Replacement: Direct replacement for same series; no firmware differences
6. Installation & Usage
Power Off: Disconnect drive power before inserting/removing.
Rack Slot: Insert into dedicated drive rack slot; secure with retainers.
Connections: Plug into backplane; use front‑panel jacks for probes.
Operation: Power up; select test points; read voltage/ signal levels.
Calibration: Adjust onboard pots for meter accuracy if needed.
Common Uses: Check DC bus, control voltages, sensor signals, I/O status.
Get a Quote