WAGO 753-455

WAGO 753-455 is rugged 4-channel analog input module of WAGO 753 I/O-SYSTEM, single-ended 4~20mA signal acquisition. The 4-channel analog input module collects analog process signals from pressure, flow, level and temperature transmitters. This 4-channel analog input module uses CAGE CLAMP spring terminal wiring, 12-bit resolution, supports DIN rail installation. The 4-channel analog input module communicates with WAGO fieldbus master via internal manifold bus, with built-in wire-break detection.

This module delivers multi-channel 4-20mA analog signal conditioning for industrial and marine automation. The multi-channel 4-20mA analog signal conditioning continuously converts current signals into digital values for PLC calculation. The multi-channel 4-20mA analog signal conditioning automatically identifies sensor open-circuit faults and sends diagnostic feedback. The multi-channel 4-20mA analog signal conditioning monitors signal quality for fuel, lube and seawater process measurement. The multi-channel 4-20mA analog signal conditioning supports hot module replacement during maintenance shutdown.

This WAGO spare is an essential industrial analog acquisition spare for automation cabinet overhaul. The industrial analog acquisition spare can replace faulty 753-455 modules directly. The industrial analog acquisition spare meets IEC and CE international safety standards. The industrial analog acquisition spare is widely fitted on factory, HVAC and marine engine room control cabinets.

WAGO 753-455 analog input module is matched with WAGO 753 series bus manifold. It gathers 4~20mA transmitter signals, executes fault monitoring and bidirectional data transmission, performs reliably under vibration, humidity and salt mist industrial and marine environments.