1. Basic Information

Model Code Explanation: CIMR-VCBA0002BAA

• CIMR: Standard Yaskawa inverter prefix

• VC: V1000 series designation

• BA: Single-phase AC 200~240V input specification, standard version without built-in EMC filter

• 0002: Capacity code

• BAA: Standard control board, no optional onboard filter

  Power Rating:

• HD(Heavy Duty/Constant Torque): 0.25kW, rated output 1.6A

• ND(Normal Duty/Variable Torque): 0.37kW, rated output 1.9A

  Typical Application: Small conveyors, miniature fans, small pumps, packaging auxiliary equipment, PM & induction low-power motors

2. Electrical Parameters

Input Specification

• Input: Single-phase AC 200V~240V, 50/60Hz; allowable voltage fluctuation: -15% ~ +10%安川電機e-メカサイト

3-phase Motor Output

• Output voltage: 0 ~ AC230V

• Output frequency range: 0.1Hz ~ 400Hz

• Control Mode: V/F control + Open-loop sensorless vector control (support permanent magnet synchronous motor drive)

Overload Characteristic

• HD rating: 150% rated output current for 60s; 180% for 3s

• ND rating: 120% rated output current for 60s

3. I/O Configuration

• Digital Input: 6-channel 24VDC sink/source selectable DI

• Digital Output: 3-channel DO (1 relay output + 2 open-collector outputs)

• Analog Input: 2 channels (0~10VDC / 4~20mA configurable)

• Analog Output: 1-channel 0~10V/0~20mA signal output

4. Mechanical & Environmental Data

• Protection Grade: IP20 (indoor cabinet wall-mounted installation)

• Operating ambient temperature: -10℃ ~ +50℃; Storage temperature: -20℃ ~ +60℃

• Ambient humidity: ≤95%RH non-condensing, no corrosive gas/conductive dust

• Max installation altitude: 1000m without current derating; max 3000m with power derating

• Dimension: W68 × H128 × D76mm; Net weight: approx 0.6kg

5. Standard Built-in Functions

1. Auto motor tuning, slip compensation, S-curve acceleration/deceleration setting, frequency skip function

2. Built-in PID constant speed/pressure control, energy-saving running mode

3. Multi-speed fixed frequency operation, DC injection braking for start/stop, high-flux braking

4. Complete protection: overcurrent, overvoltage, undervoltage, heatsink overheat, motor overload, output short & ground fault protection

5. Built-in RS485/Modbus-RTU communication interface; standard LED digital operator for parameter setting & fault check

6. Compliance Standard